Installing CentOS Linux 03
Step 11:
Then we are presented with a screen that lets us select a partitioning utility. In our case lets select Autopartition.
Step 12:
In automatic partitioning lets select Remove all partitions on this system. This will erase all the existing partition in the hard disk. Select ok then press spacebar.
Step 13:
Warning windows will popup reminding us of our choice. Go ahead select yes and press spacebar.
Step 14:
This is the result of the auto partitioning of our hard disk. Select ok then press spacebar.
Step 15:
This is the result of the auto partitioning of our hard disk. Select ok then press spacebar.
Step 16:
Just select ok then press spacebar
Step 17:
We are asked to provide a GRUB password. This is needed for additional security. Go ahead and supply your password.
Step 18:
This setup will now give us a chance to change the label of our Operating System. Just leave it alone for now you can try to experiment editing it when you will re-install the Operating System or edit it via grub.conf. Select ok then press spacebar.
Step 19:
For now we must select Master Boot Record (MBR). Select ok then press spacebar.
Step 20:
The network device eth0 is our Ethernet card or LAN card. Selecting Activate on boot will automatically turn on this device every system boot. If the computer you are using now is a part of a large network please ask your Network Administrator for the IP Address and subnet mask before entering and numbers to this field. You may cause some problems that will give your Network Administrator a headache. You may also violate your company policy if you won't ask permission causing you your job ;)
